One of the best things about installing remote controls for ceiling fan units is to have better control of the fan lights and speed without going direct to its control board. You will just sit in the room with your remote and adjust the speed of the fun conveniently.
However, installing a remote control for your fan is not as simple as cleaning fan blades. In fact, it is delicate and difficult, considering the code setting and wire connections you need to set up to make sure it is working well.
Today, this guide will walk you through the right steps you need to know when installing remote control for your fan for the first time.
Materials and Tools You Need
- Wire nuts
- Remote control
- Ceiling fan switch
- Capacitor
- Cutter/wire stripper
- A non-contact voltage tester
- Needle-nose pliers
- Electrical tape
- 4-in-1 screwdrivers
When You Need a Remote
Usually, installation can be a little tricky simply because your home has a concrete ceiling plus another floor above. That means you will not be able to add wiring or another wiring to the ceiling and can’t do wiring down the walls.
In this case, the largest selection of ceiling fan replacement remotes will come in handy. The first option you can consider is replacing the lights and using the current wiring. The second option involves adding wiring to your ceiling. But you don’t have to run the wiring down your walls.
Usually, remotes are convenient, particularly in the bedroom. This is true if you want to change the fan’s speed settings without the need of getting up.
Steps for Installing
The ability of turning a ceiling fan off and on using a remote control makes life more convenient and easier. Fortunately, adding any remote to your ceiling fan is not difficult, even when it didn’t have one when you bought it. You can still install one with the help of the following steps:
- Prepare for installation – Before you get started, take some precautionary steps to make sure the whole procedure goes off without any problem. Firstly, power your fan up to the highest setting and switch it off. Afterward, go to the circuit breaker and then switch off the power. Lastly, wear protective gloves, take a sturdy ladder, and start working on the internal components of your fan.
- Connect and fix the receiver – Once you determine where the wires need to go, make connections and keep everything secure and snug. Then use foam tape to attach your receiver and then close the canopy.
- Rebuild your fan and power it up – After affixing the receiver, start to rebuild your fan. Every ceiling fan is created uniquely. So read the instructions first. Lastly, go back to the circuit breaker and switch it on to power your fan. Insert new batteries into your remote control and test it by turning turn on and off severally to ensure it is working well.
Conclusion!
If you are tired of standing up and down so you can change your ceiling fan, then it is high time you consider adding remote control to the setup. This way, you will change the fan into the remote control you’ve always wanted.
